Will a 16–32 mm Hole Saw Set Cover Your Hardware List?

A drawing calls for a 22 mm panel opening and a 28 mm opening on the same enclosure. A cutter set marked “16–32 mm” sounds as though it covers both. Open the case and the distinction matters: the PWS set includes a 22 mm cutter, while 28 mm falls between the supplied sizes.

PWS 6-piece TCT hole saw set with pilot drill bits in protective storage case, sizes 16mm to 32mm.

Match each cutout to an actual cutter

The six tungsten-carbide-tipped cutters in this set are 16, 20, 22, 25, 30 and 32 mm. Start with the finished cutout on the hardware drawing. The outside diameter of a fitting, its thread designation and the opening its manufacturer specifies can be different dimensions.

Work through one panel before buying for the batch

Suppose ten panels each need two 22 mm openings and one 28 mm opening. The set covers twenty openings. You still need a plan for the ten 28 mm holes. Rounding a cutout up to 30 mm can leave too little material for the fitting to seat properly. Check the permitted tolerance before substituting a size.

Put material and thickness on the list

Record the sheet material and thickness beside each diameter, and check cutter depth, shank fit and tool compatibility before ordering. For repeated work, make a test opening in offcut material of the same thickness and try the actual fitting before committing the finished panels.

See the PWS 6-piece TCT hole saw set.

Loading views...
Share this article
FacebookWhatsAppLinkedIn

Leave a Comment

Shopping Cart

Save to list

Scroll to Top